Electric Vehicle Charging
EV Charger Installation
Fast, safe charging at home
Charging an electric vehicle from a standard power outlet is slow and running overnight electricity is expensive. A dedicated wall charger on its own circuit—ideally paired with a solar system—lets you charge when the sun generates spare power. Solar Advice supplies, installs and tests chargers with SAA-accredited electricians, including any electrical upgrades your home needs.
⏳ Deadlines
- Cheaper Home Batteries steps down in 66 days (1 January 2027)About $252/kWh for the first 14 kWh, $151/kWh to 28 kWh and $38/kWh to 50 kWh (2026 rate) Source: DCCEEW Cheaper Home Batteries, from 1 May 2026 · checked 2026-10-16
- STC discount on new solar shrinks in 66 days (1 January 2027)about 20% less than this year (one fewer deeming year) Source: Clean Energy Regulator (small-scale technology certificates) · set by law
Why a dedicated EV charger matters
Charging an EV from a standard 10A outlet (the three-pin socket on your wall) costs more and takes far longer—typically 10–20 hours to add 100 km of range. Using a standard circuit also risks overloading old household wiring. A dedicated charger on its own circuit, rated for the job, is safer, faster and cheaper to run.
When you pair a charger with solar panels, you charge mostly for free on sunny days and minimise your reliance on grid electricity during expensive peak hours. A solar-aware smart charger makes this automatic, so your EV charges when surplus solar power is available and pauses when the sun goes in.
What this covers
- 01
7kW single-phase wall charger
Suited to most homes with standard single-phase power. Adds 30–50 km of range per hour and uses your existing electrical supply. Typical install on a home with spare switchboard capacity takes 4–6 hours.
- 02
22kW three-phase charger
For homes and small businesses with three-phase power (common in outer suburbs and rural areas). Adds 80–160 km of range per hour. Requires confirmation that your distribution network has three-phase supply and your switchboard can handle the load.
- 03
Solar-aware smart charger
Automatically delays charging until solar panels generate surplus power, reducing your grid electricity use and charging cost. Works with existing solar systems and batteries. Requires an internet connection and compatible solar inverter.
- 04
Cable run and switchboard upgrades
If your charger location is far from the switchboard or your current panel is full or outdated, we run new cabling and upgrade circuits and protective devices. Assessment and quote completed on-site.
- 05
RCD and safety testing
Every install includes residual current device (RCD) checks and full electrical safety testing to meet Australian Standards. We provide test certificates and handover documentation.
What's included in an EV charger installation
An EV charger installation with Solar Advice starts with an on-site or phone assessment to understand your home's electrical layout, your vehicle's charging capability and how you plan to use the charger. We ask about your roof size, existing solar panels, battery storage and your typical driving patterns. This helps us recommend the right charger type and identify any upgrades needed.
Once you approve a quote, we supply the charger (brand and warranty of your choice), run any new cabling, upgrade your switchboard if necessary, and install the unit to Australian electrical standards. Our SAA-accredited electricians test the installation, confirm all safety devices work correctly and provide you with warranty documents and a handover briefing. Typical turnaround is 2–4 weeks from quote to completion, depending on material availability and your diary.
If your home needs a significant electrical upgrade—such as a new switchboard, three-phase installation, or a cable run over 20 metres—we quote these separately so there are no surprises. Common upgrades include installing a new 63A main breaker, adding a dedicated 32A or 63A subcircuit for the charger, and fitting a Type A RCD to protect the charger circuit.
Combining EV charging with solar and batteries
If you already have solar panels, a smart EV charger can make your system work much harder. On a sunny day when your panels generate more power than your home uses, the charger can automatically start, soaking up that spare energy for free. This strategy cuts your charging costs to near zero on high-generation days and reduces the amount of solar power exported to the grid at low rates.
If you add a home battery (such as under the Cheaper Home Batteries Program, with rebates available from 1 May 2026), a smart charger can prioritise charging the vehicle during peak solar hours and reserve battery capacity for evening peak electricity rates. This layered approach—solar, battery, smart charger—requires compatible equipment and correct settings, but maximises savings. Solar Advice can design and install the full system so each component works together.
Confirm current battery rebate amounts and eligibility with the Clean Energy Regulator. The Cheaper Home Batteries Program rates from 1 May 2026 are approximately $252/kWh for the first 14 kWh of storage, $151/kWh from 14–28 kWh, and $38/kWh from 28–50 kWh. Your actual rebate depends on your state and the battery model.
Pricing guide
How much does an EV charger cost to install?
A typical EV charger installation in Australia costs $1,200–$3,200 per unit, depending on whether your home needs electrical upgrades, the charger type and brand, cable run distance and your suburb's network operator requirements. Most homes with adequate spare switchboard capacity and a charger location close to the board pay towards the lower end; homes needing three-phase upgrades, RCD installation or long cable runs pay more.
- Charger power rating: 7kW (single-phase) is cheaper than 22kW (three-phase); smart chargers cost $300–$600 more than basic models.
- Electrical upgrades: if your switchboard has spare capacity and an RCD is already fitted, installation is quicker and cheaper. Older homes or those with full panels may need a new subcircuit breaker ($300–$600) or RCD retrofit ($400–$800).
- Cable run distance: chargers within 5 metres of the switchboard are standard; cable runs over 15 metres add $200–$400 per 5 metres of run.
- Three-phase availability: if your street has three-phase power but your home is connected to single-phase, upgrading costs $1,500–$3,000. Some network operators (such as Ausgrid in NSW or Powercor in Victoria) apply their own pricing.
- Site access: chargers installed on the front of the house are faster than those on a garage roof or rear wall. Difficult roof or eaves access may add 2–4 hours labour.
- Brand and warranty: entry-level chargers (5-year warranty) start at $600–$800; premium models with 10-year warranties and advanced features cost $1,200–$1,800. Installation labour is typically $400–$800 regardless of brand.
| Job type | Low | Typical | High |
|---|---|---|---|
| 7kW single-phase charger (basic install, existing circuit) | $1,200 | $1,600 | $2,000 |
| 7kW charger with new 32A circuit and RCD upgrade | $1,600 | $2,100 | $2,600 |
| 22kW three-phase charger (includes three-phase assessment and installation) | $2,200 | $2,800 | $3,600 |
| Solar-aware smart charger with solar integration and monitoring app | $1,800 | $2,400 | $3,200 |
The Cheaper Home Batteries Program (1 May 2026 rates: ~$252/kWh for 0–14 kWh, ~$151/kWh for 14–28 kWh, ~$38/kWh for 28–50 kWh) applies to battery storage only, not chargers. Confirm current rebates with the Clean Energy Regulator. Small-scale Technology Certificates (STCs) under the Small-scale Renewable Energy Scheme do not apply to chargers; they apply only to solar panels and batteries.
Typically included
- On-site or remote electrical assessment and recommendation
- Written, itemised quote with equipment brands and warranty terms
- Supply of the EV charger unit and all cabling and components
- Installation by a licensed and SAA-accredited electrician
- Switchboard circuit and RCD checks; upgrades quoted separately if needed
- Full electrical testing to Australian Standards; test certificate and handover document provided
Often excluded
- Charger warranty claims after handover (managed by the manufacturer)
- Repairs to existing home wiring or switchboard (quoted separately if discovered during assessment)
- Three-phase network upgrade by your distribution network operator (you pay the network operator directly)
- Replacement of the charger if it fails after the warranty period
Do not attempt to install an EV charger yourself. Installation must be completed by a licensed electrician accredited with Solar Accreditation Australia (SAA) or equivalent state credentials. Incorrect installation risks electric shock, fire and voiding your charger warranty. Your home's switchboard must be assessed before installation; some older or overloaded panels cannot safely support a dedicated charger circuit without upgrade. Confirm with your local council or building manager whether your property (especially strata schemes or heritage-listed homes) requires approval.
Questions to ask every installer
- 1Is the electrician installing your charger SAA-accredited and licensed in your state?
- 2Does the quote include switchboard assessment, all cabling, RCD installation and full testing?
- 3What charger brands and warranty terms are available, and does the warranty cover parts and labour?
- 4If my home needs a three-phase upgrade or long cable run, is that quoted separately and clearly itemised?
- 5Will you provide a test certificate and handover document confirming the charger meets Australian Standards?
Brands we install
Brands we install
Ask us about current stock and warranty terms for each brand.
- Panels
- JinkoTrinaLONGiAikoRECCanadian SolarSunPower (Maxeon)
- Inverters
- FroniusSungrowSolarEdgeEnphaseGoodWeHuawei
- Batteries
- Tesla PowerwallSigenergyBYDAlpha ESSEnphase IQ BatterySungrow SBRFranklinWH
Solar designed around your situation
Which situation best suits you?
What's the difference between 7kW and 22kW chargers?
Can I charge my EV from solar panels?
Does EV charger installation qualify for federal rebates?
What electrical work might I need before installation?
How long does installation take?
What happens if my charger breaks down?
Do I need planning permission to install an EV charger?
How does a smart charger save me money?
Get a tailored EV charger quote
Book a free on-site or phone assessment with an accredited electrician.